Spacelog Apollo 13

Okay. That's the panel 8 floodlights. Now we're going to take panel 5 and put the FLOODLIGHT rheostat to FLOOD and the LEB, that's panel 100, FLOODLIGHTS are also going to FIXED. And the purpose of this is to balance up buses A and B.

Okay. Panel 5; FLOODLIGHTS; you want the rheostat on. Panel 100, FLOODLIGHTS; you want FIXED.

That's affirmative. Okay. On panel 8: circuit breakers EMS, MAIN A and MAIN B, that's two, open.

Okay. Panel 8: EMS MAIN A and MAIN B, open.

Okay. On panel 250: circuit breaker BATTERY A POWER ENTRY and POSTLANDING, closed.

Okay. Panel 250: CB BAT A POWER ENTRY and POSTLANDING, closed.

Okay. The same for circuit breaker BATTERY B POWER ENTRY and POSTLANDING.

Okay. BATTERY B POWER ENTRY and POSTLANDING, closed.

Okay. And add BATTERY C POWER ENTRY and POSTLANDING.

BATTERY C POWER ENTRY and POSTLANDING, closed.

Okay. That's correct. On panel 5: circuit breaker BAT CHARGE, BATTERY A CHARGE, closed.

Okay. Panel 5: CB BAT CHARGE, BAT A, close.

Okay. And the same for circuit breaker for BATTERY CHARGE, BAT B/CHARGE, closed.

Okay, BAT CHARGER, BAT B, closed.

All right. Like to take MAIN BUS TIES, two of them, on and up. That's probably a verify.

MAIN BUS TIES A/C and B/C, on, verify.

That's correct. Circuit breaker BATTERY RELAY BUS, BATTERY A and B, closed.

Okay. CB BAT RELAY BUS, BAT A, and BAT RELAY BUS, BAT B, closed.

That's affirmative. Circuit breaker EPS SENSOR SIGNAL, MAIN A and MAIN B, closed.

Okay. Good. On panel 276: circuit breaker INSTRUMENTATION POWER CONTROL, 3 and 4, open.

Would you say that one again, Ken?

All right. On panel 276: circuit breaker INSTRUMENTATION POWER CONTROL, 3 and 4, open.

Okay. Panel 276: CB INSTRUMENTATION POWER CONTROL, 3 and 4, open.

That's affirmative. Okay. Panel 5: circuit breaker CENTRAL INSTRUMENTATION POWER, MAIN B, closed.

Okay. On panel 5: …

Okay. I'm sorry, Jack. Would you read that again, please?

Okay. On panel 5: CB CENTRAL INSTRUMENTATION POWER, MAIN B, closed.

Okay. That's correct. PRIMARY EVAPORATE WATER CONTROL valve to AUTO.

This is on 382?

That's affirmative.

Wha—Wha -

Okay, Jack. We want to put the PRIMARY and the SECONDARY EVAPORATED WATER CONTROL valves to AUTO.

Okay.

And, Jack, can you give us a readout on BAT B and the charger current?

Okay, Ken. That was the PRIMARY and SECONDARY H₂O CONTROL valves to AUTO on 382.

That's affirmative, and did you copy about the readout on the battery and charger?

Yes. Jim's on his way up.

Okay. Thank you. All right, the next little step after your water control valves is to perform the CSM RCS preheat. We'll do that on page E/1-5, steps 35 and 37.

Okay, Ken. We're having a problem with the COMM. You read now?